DèLonghi ECAM45.76X Instructions For Use Manual page 25

The coffee is delivered too slowly or a
drop at a time.
Coffee does not come out of one or
both of the spouts.
The appliance does not come on
The infuser cannot be extracted
The milk does not
come out of the milk
spout (D5)
The milk contains
large bubbles and
squirts out of the
milk spout (D5) or
there is little froth
The milk contains
large bubbles and
squirts out of the
milk spout or there is
little froth.
The coffee is ground too finely.
The coffee spouts (A7) are blocked.
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A19) is not turned on. Press the main switch (fig. 2).
The appliance has not been turned off
correctly
The milk container lid (D2) is dirty.
The milk is not cold enough or is not
semi-skimmed.
The froth adjustment dial (D1) is incor-
rectly adjusted.
The milk container lid (D2) or froth
adjustment dial (D1) are dirty.
The hot water/steam connection noz-
zle (A8) is dirty.
The cappuccino maker/ hot water
spout (C6) is dirty.
24
Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
mill is in operation (fig. 14). Continue one click
at a time until coffee delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see section "8.4 Adjusting the coffee
mill").
Clean the spouts with a toothpick (see section
"11.7 Cleaning the coffee spouts").
Turn the appliance off by pressing the
button (B1-fig. 8) (section "6. TURNING THE AP-
PLIANCE OFF").
Clean the milk container lid as described in sec-
tion "11.10 Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrige-
rator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section
"9. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES".
Clean the milk container lid and dial as de-
scribed in section "11.10 Cleaning the milk
container".
Clean the connection nozzle as described in
section "11.11 Cleaning the hot water/steam
connection nozzle".
Clean as described in section "10.5 Cleaning
the spout after use".