Table of Contents
Advertisement
5. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A19) is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A7) and is collected in the drip tray (A12) underneath. Avoid
contact with splashes of water.
•
To turn the appliance on, press the
8). The message "Heating up, Please wait" appears on the
display (B13).
When heating is complete, the message changes to "RINSING".
As well as heating the boiler, this also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coffee appears.
6. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A7). Avoid contact with splashes of water.
•
To turn the appliance off, press the
8).
•
The message "Turning off underway Please wait" appears
on the display (B13), then, if necessary, the appliance per-
forms a rinse cycle and goes off (standby).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
•
first turn the appliance off by pressing the
•
release the main switch (A19) at the back of the appliance
(fig. 2).
Important!
Never press the main switch while the appliance is on.
7. MENU SETTINGS
7.1
Rinsing
Use this function to deliver hot water from the coffee spout (A7)
and from the cappuccino maker/hot water spout (C6), if insert-
ed, to clean and heat the appliance's internal circuit.
Place a container with a minimum capacity of 33,38 fl.oz/100 ml
under the cappuccino maker/hot water spout (fig. 7).
To enable the function, proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (fig. 9) until "Rinsing" appears on
the display (B13);
3. Press the OK button (B12-fig. 10): the message "Confirm?"
is displayed;
Do not leave the appliance unattended while hot water is being
delivered.
4. Press the OK button. "RINSING Please wait" is displayed;
5. After a few seconds, hot water is delivered first from the
coffee spouts (A7), then from the cappuccino maker/hot
button (B1-fig.
water spout (C6) (if inserted) to heat the appliance's inter-
nal circuit. "RINSING" is displayed, together with a progress
bar which fills gradually as preparation proceeds;
6. To stop the process press any button or wait for delivery of
water to stop automatically.
•
If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
•
After cleaning, it is normal for the grounds container (A10)
to contain water.
7.2 Descaling
For instructions on descaling, see section "12. DESCALING".
button (B1- fig.
7.3 Install filter
For instructions on how to install the filter, see section "14.
WATER SOFTENER FILTER".
7.4 Replacing the water softener filter (if
For instructions on how to replace the filter, see section "14.2
Replacing the filter".
button;
7.5 Adjust time
To adjust the time on the display (B13), proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (fig. 9) until "Adjust time" is
displayed;
3. Press the OK button (B12-fig. 10): the hours flash on the
display;
4. Press < or > to change the hour;
5. Press the OK button to confirm. The minutes flash;
6. Press < or > to change the minutes;
7. Press the OK button to confirm.
The time is set. Press the MENU/ESC button to exit the menu.
10
Danger of burns!
Please note!
installed)
Advertisement
Table of Contents
Troubleshooting
