Access Decoder Channel; Start A Tv Demo; Reset The Tv To Factory Settings - Philips 19PFL5404/60 User Manual

Access decoder channel

You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1.
Set decoder channel
Map channels from a decoder or descrambler
1
Press (Home).
2
Select [Setup] > [Installation] >
[Decoder].
3
Press to enter [Decoder].
4
Press to enter [Channel].
5
Press to select channel number to
map to the decoder/descrambler channel.
6
Press OK.
7
Press to select and enter [Status].
8
Press to select the connector used
by the decoder/descrambler ([None] or
[EXT 1]).
9
Press OK.
10
Press (Home) to exit.
Note
•
Select [None] if you do not want to map to
the decoder/descrambler channel.

Start a TV demo

1
Press DEMO on the remote control.
2
Press to select a demo and press OK
to view it.
3
Press DEMO to exit.
20 EN
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. Channel installation settings
remain the same.
1
Press (Home).
2
Select [Setup] > [Installation] > [Factory
settings].
3
Press OK or to enter the [Factory
settings] menu.
» [Reset] is highlighted.
4
Press OK to reset to factory settings.
5
Press (Home) to exit.