Philips PerfectCare Pure GC7619/25 User Manual page 24

Problem
EN The appliance does not produce
any steam.
The appliance beeps and less or
no steam comes out of the iron
when I press the steam trigger.
The 'ANTI-CALC cartridge
replacement' light keeps flashing.
The appliance produces a loud
pumping sound (subtle pumping
sound is normal).
The appliance has switched off.
The iron leaves a shine or an
imprint on the garment.
The ironing board cover
becomes wet or water droplets
come out of the soleplate.
There is too much steam
coming out of the iron.
24
4239_000_8956_3_Picture_Rich_A5_v4.indd 24
Possible cause
There is not enough water in the
water tank.
You have not pressed the steam
trigger.
You have just installed a new
ANTI-CALC cartridge.
The ANTI-CALC cartridge is not
placed properly.
You have to replace the
ANTI-CALC cartridge.
You have to replace the
ANTI-CALC cartridge.
You have just installed a new
ANTI-CALC cartridge.
The water tank is empty.
The ANTI-CALC cartridge is not
in place.
The ANTI-CALC cartridge is
damaged or shows cracks or
hairline cracks.
The safety auto-off function is
activated automatically when the
steam generator has not been
used for more than 5 minutes.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a
fold in the garment.
Steam has condensed on the
ironing board cover after a long
ironing session.
You may have an ironing board
that is not designed to cope with
the high steam rate of the steam
generator.
The default setting of the iron is
the OptimalTemp setting. In this
setting the iron provides a high
steam output.
Solution
Fill the water tank beyond the MIN indication.
Press and hold the steam trigger until steam
comes out. It may take up to 30 seconds until
steam comes out.
Press the steam trigger and keep it pressed when
you steam iron.
Press and hold the steam trigger for 10 seconds
until steam comes out.
Press down the ANTI-CALC cartridge until it
locks into position.
Replace the ANTI-CALC cartridge (see
You can also use demineralised water or descaled
water from the IronCare. In that case, you
need to leave the exhausted cartridge in the
compartment.
Replace the ANTI-CALC cartridge (see
You can also use demineralised water or descaled
water from the IronCare. In that case, you
need to leave the exhausted cartridge in the
compartment.
Continue to press the steam trigger until the
pumping sound stops and steam comes out of
the soleplate.
Refill the water tank with water and press the
steam trigger until the pumping sound stops and
steam comes out of the soleplate.
Place the ANTI-CALC cartridge (see
Inspect the ANTI-CALC cartridge thoroughly. If
you see any sign of damage or cracks, no matter
how small, replace the ANTI-CALC cartridge
with a new one.
Press the on/off button to reactivate the steam
generator.
Perfect Care is safe on all garments. The shine or
imprint is not permanent and will come off if you
wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the
area to be ironed to avoid imprints.
Replace the ironing board cover if the foam
material has worn out. You can also add an extra
layer of felt material under the ironing board
cover to prevent condensation on the ironing
board.
Put an extra layer of felt material under the
ironing board cover to prevent condensation on
the ironing board.
Activate the ECO mode to iron
with a lower steam output. See section
).
).
).
.
18/05/15 11:31