Mounting On A Wall - HP V192B.BHP Manual

10
ASSEMBLING AND PREPARING
Mounting on a wall
For proper ventilation, allow a clearance of 10 cm
on each side and from the wall.
10 cm
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1 If you use screw longer than standard, the moni-
tor might be damaged internally.
2 If you use improper screw, the product might be
damaged and drop from mounted position.
In this case, HP Electronics is not responsible
for it.
Wall Mount
100 x 100
(A x B)
Standard
M4
screw
Number of
4
screws
10 cm
10 cm
10 cm
CAUTION
Disconnect the power cord first, and then
y y
move or install the Monitor set. Otherwise
electric shock may occur.
If you install the Monitor set on a ceiling or
y y
slanted wall, it may fall and result in severe
injury.
It is important to verify that the manufacturer's
y y
mounting solution is compliant with the VESA
standard and is rated to support the weight of
the display head.
D o not over tighten the screws as this may
y y
cause damage to the Monitor set and void
your warranty.
U se only screws and wall mounts that
y y
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
Screw length from outer surface of back
y y
cover should be under 8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
NOTE
Use the screws that are listed on the VESA
y y
standard screw specifications.
The wall mount kit will include an installation
y y
manual and necessary parts.
The wall mount bracket is optional. You can
y y
obtain additional accessories from your local
dealer.
The length of screws may differ depending
y y
on the wall mount. Be sure to use the proper
length.
For more information, refer to the
y y
instructions supplied with the wall mount.
Back Cover
Max.8mm