Table of Contents
Advertisement
Chapter 5. Menu
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
A nynet+ is a function that enables you to control all connected Samsung devices
that support Anynet+ with your Samsung product remote. The Anynet+ system can
be used only with Samsung devices that have the Anynet+ feature. To be sure your
Samsung device has this feature, check if there is an Anynet+ logo on it.
• You can only control Anynet+ devices using the product remote control, not the
buttons on the product.
• The product remote control may not work under certain conditions. If this occurs,
reselect the Anynet+ device.
•
A nynet+
works when the AV device supporting
status.
• While in
PIP
mode,
Anynet+
functions only when an AV device is connected as
the primary display. It does not work if the AV device is connected as a secondary
display.
•
A nynet+
supports up to 12 AV devices in total. Note that you can connect up to 3
devices of the same type.
Anynet+
is in the standby or on
Troubleshooting for Anynet+
Problem
Possible Solution
Anynet+ does not
• Check if the device is an Anynet+ device. The Anynet+
work.
system supports Anynet+ devices only.
• Check if the Anynet+ device power cord is properly
connected.
• Check the Anynet+ device's Video/Audio/HDMI cable
connections.
• Check whether
System
• Check whether the remote control is Anynet+
compatible.
• Anynet+ doesn't work in certain situations. (initial
setup)
• If you have removed and then reconnected the HDMI
cable, please make sure to search devices again or turn
your product off and on again.
• Check if the Anynet+ function of the Anynet device is
set on.
I want to start
• Check if the Anynet+ device is properly connected to
Anynet+.
the product and check if the
to
On
in the
I want to exit Anynet+.
• Press the
and select a non- Anynet+ device.
The message
• You cannot use the remote control when you are
"Disconnecting
configuring Anynet+ or switching to a view mode.
Anynet+ device ..."
• Use the remote control after the product has
appears on the screen.
completed Anynet+ configuration or has finished
switching to Anynet+.
Anynet+ (HDMI-CEC)
is set to
On
menu.
Anynet+ (HDMI-CEC)
System
menu.
button on the product remote control
SOURCE
72
in the
is set
Advertisement
Table of Contents
