Table of Contents
Advertisement
Instructions for the installer
2. Positioning of hob
This appliance shall be installed only by authorized persons in
accordance with AS5601 - Gas Installations, any statutory
regulations, local gas regulations, municipal building codes,
electrical wiring regulations, and the manufacturer's installation
instructions.
Clearance around the appliance must comply with the requirements
of AS5601.
The following operation requires building and/or carpentry work so
must be carried out by a competent tradesman. Installation can be
carried out on various materials such as masonry, metal, solid wood
or plastic laminated wood as long as they are heat resistant
(T 90°C). Never use silicone or other insulating products when
installing the appliance; use only the rubber gasket provided.
2.1 Attachment to support structure
Create an opening with the dimensions
shown in the figure in the top surface of
the counter, keeping a minimum distance
of 50 mm from the rear border.
This device is classified "type Y" as
regards risks against fire and it can be set
adjacent to walls that are higher than the work surface, provided
that a distance of 145 mm. is respected (as shown in the figure) to
prevent damage due to overheating. Make sure there is a minimum
of 750 mm between the hot plate flames and any shelf that may be
installed directly above them. Carefully position the insulation
gasket (supplied) on the external perimeter of the hole made in the
top surface (see figures below) and try to make it stick to the entire
surface by applying light pressure with your hands. Refer to the
coordinates shown in the figure, bearing in mind that sides A should
be adjacent to the hole. Secure the hob to the counter with brackets
B (supplied). Carefully trim any excess from border C of the gasket.
5
Advertisement
Table of Contents
