Advertisement
Cleaning and Maintaining
Problem
The air conditioner
is not turned on or
off immediately
with the wired
remote control.
The Timed on/off
function does not
operate.
The indoor unit
display blinks
continuously.
I want to get cooler
air.
The air is not cool or
warm enough.
18
English
• Check whether the wired remote control is set for group control. In this
case, the air conditioners connected to the wired remote control are
turned on or off sequentially. This operation takes up to 32 seconds.
• Check whether you pressed the
after setting the on/off time. Set the on/off time.
• Turn on the air conditioner again by pressing the
• Turn off and then turn on the auxiliary power switch, and then turn on
the conditioner.
• If the indoor unit display is still blinking, contact a service centre.
• Operate the air conditioner with a electric fan to save energy and
enhance the cooling efficiency.
• In the Cool mode, cool air does not come out if the set temperature is
higher than the current temperature.
– MR-EH00 remote control: Press the Temperature button repeatedly
until the set temperature (minimum: 18°C) is set to lower than the
current temperature.
– AR-KH00E remote control: Press the Temperature button on the
remote control. Then rotate the Wheel until the set temperature
(minimum: 18°C) is set to lower than the current temperature.
• In the Heat mode, warm air does not come out if the set temperature is
lower than the current temperature.
– MR-EH00 remote control: Press the Temperature button repeatedly
until the set temperature (maximum: 30°C) is set to higher than the
current temperature.
– AR-KH00E remote control: Press the Temperature button on the
remote control. Then rotate the Wheel until the set temperature
(maximum: 30°C) is set to higher than the current temperature.
• Both cooling and heating do not operate in the Fan mode. Select the
Cool, Heat, Auto, or Dry mode.
• Check whether the air filter is blocked with dirt. A dusty filter may
decrease the cooling and heating efficiencies. Clean the air filter
frequently.
• If a cover is on the outdoor unit or any obstacle is present near the
outdoor unit, remove them.
• Install the outdoor unit in a well-ventilated place. Avoiding places
exposed to direct sunlight or close to a heating appliance.
• Place a sunscreen over the outdoor unit to protect it from direct sunlight.
• If the indoor unit is installed in a place exposed to direct sunlight, pull
the curtains on the windows.
Solution
(SET) button on the remote control
(Power) button.
Advertisement
