Water Dispenser - Electrolux ICON Designer E23BC78ISS Use And Care Manual

Temperatures Are Too Warm (continued)
Problem Cause
Refrigerator temperature • Refrigerator control is set too warm.
is too warm. Freezer
temperature is
satisfactory.
•
Temperature in the Temperature control is set too warm.
Deli Drawer or Custom
Temp Drawer is too
TM
warm (select models).

Water Dispenser

Problem Cause
Dispenser will not dispense • Water supply is not connected.
water.
• Household water line valve is not open.
•
Ice & water filter cartridge is clogged.
Water has an odd taste • Water has been in the tank for a period of time.
and/or odor.
• Unit not properly connected to cold water line.
•
Tubing used in the household water supply and
installation may affect water taste and odor.
• Water has a high mineral content.
Water pressure is • Cut-off and cut-on pressures are too low (well
extremely low. systems only).
• Reverse osmosis system is in regenerative phase.
Water/Moisture/Frost Inside Refrigerator
Problem Cause
Moisture collects on • Weather is hot and humid.
inside of refrigerator
walls. • Door is slightly open.
• Door is opened too often or too long.
•
Open containers.
Water collects on bottom • Vegetables contain and give off moisture.
side of drawer cover.
•
Moisture collects in Washed vegetables and fruit drain while in
bottom of drawer. the drawer.
• Fruits and vegetables are kept past their
prime
Moisture collects on • Weather is humid.
outside of refrigerator or
between doors. • Door is slightly open, causing cold air from
inside refrigerator to meet warm air from
outside.
Solutions to Common Problems
Correction
• Set refrigerator control to a colder setting. Allow 24
hours for temperature to stabilize.
•
Adjust temperature control to a colder setting.
Correction
• Connect water supply (see Connecting The Water Supply
section).
• Open household water line valve. See Problem section Ice
Maker Is Not Making Ice.
•
Replace filter cartridge being sure to remove protective caps.
• Draw and discard 10-12 glasses of water to freshen the
supply and completely rinse out the tank.
• Connect unit to cold water line that supplies water to the
kitchen faucet.
•
For best results, use copper tubing for water connections.
• Contact water treatment plant for help in checking water
supply source.
• Have someone turn up the cut-off and cut-on pressure on
the water pump system (well systems only).
• It is normal for a reverse osmosis system to be below 20 psi
during the regenerative phase.
Correction
• The rate of frost buildup and internal sweating
increases.
• See Problem section, Opening/Closing of Doors/
Drawers.
• Open door less often to allow internal temperature to
stabilize.
•
Keep containers covered.
• Moisture on the bottom side of the cover is not unusual.
• Move humidity control (select models) to lower setting.
•
Dry items before putting them in the drawer. Water
collecting in bottom of drawer is normal.
• Routinely clean out old fruits and vegetables especially if
they begin to break down.
• This is normal in humid weather. When humidity is
lower, the moisture should disappear.
• See Problem section, Opening/Closing of Doors/
Drawers.
33