Electrolux ICON Designer E23BC78ISS Use And Care Manual page 9

4 Lift the door while adjusting the washer. To
raise the door, rotate washer clockwise (when
viewed from the bottom). To lower door, rotate
washer counter-clockwise (when viewed from the
bottom).
Raising/Lowering Door
5 Re-tighten the set screw, ensuring it is between
the spokes of the set washer. Set screw will not
be tight, just insert until it is flush with the hinge.
To adjust the flipper mullion:
1 Loosen the set screw located on the flipper
mullion hinge.
Adjusting Flipper Mullion Screw
Set Screw
Installation
2 Adjust flipper mullion height. For proper
connection with the flipper mullion guide, there
should be a separation about the thickness of a
coin (0.060 inches, or 1.5 mm) between the guide
and flipper mullion.
Adjusting Flipper Mullion Height
3 Re-tighten set screw.
9