Automatic Water Dispenser - Electrolux EI33AR80WS Use & Care Manual

22

AUTOMATIC WATER DISPENSER

Your refrigerator might be equipped with an
internal water dispenser mounted inside the
cabinet, along the left-hand cabinet wall
(varies by model).
Before using the water dispenser for the first
time or after changing the water filter, you must
prime your water supply system.
Priming the water supply system
CAUTION
For proper dispenser operation, the
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause the system
to malfunction.
Using the dispenser after installation:
If the system is not flushed, the first glass of
water may have discolored water or have
an odd flavor.
1. Begin filling the system by pressing
a drinking glass against the water
dispenser paddle.
2. Keep the glass in this position until the
water comes out of the dispenser. It
may take about 1½ minutes.
3. Continue dispensing water for about
4 minutes to flush the system and
plumbing connections of any
impurities (stopping to empty the
glass as necessary).
If the water dispenser function becomes
disabled, enable the water dispenser by
pressing and holding WATER DISP on the
appliance control display. When the water
dispenser is turned on, the LEDs above
WATER DISP are illuminated.

NOTE
If you prefer to keep the internal water
dispenser disabled, use the appliance
display to disable it. The LEDs will not be
illuminated above WATER DISP.
Water Dispenser On
The water nozzle inside the cabinet allows
the water nozzle (A) to be recessed against
cabinet when not in use and to be extended
outward when in use. To use the water
dispenser, push the water nozzle (A) so it
is fully extended. Place a cup against the
paddle (B) and press to dispense water.

NOTE
Optional: Lock the water dispenser
back in place by pushing the water
nozzle back in when you have finished
dispensing water.
A
B
Water Dispenser Off