Electrical Wire Diagram - Dansons Group Pit Boss Copperhead 5 Series Operating Instructions And Recipes

The Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical shorts,
consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
110-120V, 60Hz, 250W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and certification services, comply
with a testing tolerance of ± 5-10 percent.
DISCONNECT POWER
SUPPLY BEFORE SERVICE
OR MAINTENANCE.
FUEL INPUT
GROUNDED
POWER CORD
RATING:
VW-1, 105°C/221°F,
1.1 KG/H
18-3 STANDARD CSA
(2.4 LB/H)
BURN POT
INDEX
W : WHITE
Y : YELLOW
P : PURPLE
R : RED
K : BLACK
S : SILVER

ELECTRICAL WIRE DIAGRAM

REMOVE TWO GREASE
TRAY BRACKETS FROM
UNDERSIDE OF UNIT.
K K
W W
G
GROUND
W
P
W W
W
W
IGNITER ASSEMBLY /
HD CARTRIDGE HEATER
200W, 120V
REMOVE WIRE COMPONENTS
HOUSING FROM UNDERSIDE
OF UNIT.
K
GRILL PROBE SPADE
CONNECTORS
FAST-BLOW FUSE
P Y
P Y
R
W W
R R
AUGER MOTOR
& FEED SYSTEM
120V, 60Hz 2 RPM MOTOR
ACCESS WIRING COMPONENTS
LOCATED IN GRILL PROBE
HOUSING.
GRILL
PROBE
CONTROL BOARD
Y
Y Y
DRAFT FAN
120V, 60Hz, 1 PHASE
23