Replace The Filter And Wick; Understanding The Healthy Air Protect Lock; Replacing The Nanoprotect Filter - Philips HU5930/10 User Manual

Note
• Please use mid or acid cleanser
• White vinegar (5% acetic acid) mix
with equal amount of water
• 4L water + 24g citric acid
• If there are white deposits
(limescale) on the lter, make
sure that the side with the white
deposits is immersed in the water.
• Do not take the NanoCloud rotary
humidication wick off the wheel
during descaling.
5
Let the NanoCloud rotary
humidication wick soak in the
solution for 2 hours (fig. „).
6
Rinse the NanoCloud rotary
humidification wick under the tap to
rinse away vinegar residues. During
rinsing, turn the wick so that both
front and back are rinsed (fig. ...).
7
Air dry the NanoCloud rotary
humidification wick (fig. †).
Note
• Do not put the NanoCloud rotary
humidification wick under direct
sunlight.
8
Touch and hold the reset button
for 3 seconds to reset the
NanoCloud rotary humidification
wick cleaning time (fig. ƒ).
12 EN
6 Replace the
filter and wick
Understanding the
healthy air protect lock
This appliance is equipped with the
healthy air protect lock to make sure
that the Nano protect filter and the
humidification wick are in optimal
condition when the appliance is
operating. When the Nano protect filter
and the humidification wick are almost
expired, the replacement light
to flash to indicate that they need to be
replaced.
If you do not replace the filter and
wick in time, the appliance will stop
operating and get locked.
Replacing the
NanoProtect filter
Note
• The NanoProtect filter is not
washable nor vacuum cleanable.
Filter alert light
status
Filter replacement
light starts
flashing (fig. ‡)
1
Remove the used NanoProtect filter
from the appliance (fig. ˆ).
starts
Follow this
Replace the
NanoProtect
filter