Turning Power On/Off; Turning On The Main Power - Sharp PN-75HC1 Operation Manual

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

Turning on the main power

Main power switch
When you turn on the main power, the monitor enters standby
state.
Off mode, when main power is off.
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.
16
E

Turning Power On/Off

Turning power on/off
Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
Status
Blue lit
Red lit
* Standby mode when Power Save Mode is set to On.
Networked standby mode when Power Save Mode is set to
Off.
Networked standby mode allows the monitor to be turned
on via network (LAN, RS-232C, and HDMI CEC).
TIPS
• When the monitor is turned on for the first time after being
shipped from the factory, the settings screen appears.
• When the main power switch is off, the monitor cannot be
turned on.
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to Mode1 or Mode2.
Mode1 is the recommended setting and conforms to
the "Normal Configuration" as defined in the EcoDesign
Regulation (2019/2021).
Mode1......Off If No Signal setting can not be changed. If there
is no signal for approx. 5 minutes, this monitor
automatically enters standby mode.
Off If No Operation and Power Save Mode are set
to On. (These settings can not be changed.)
If there is no operation for 4 hours or more, this
monitor automatically enters standby mode. Power
consumption in standby state is also minimized.
Mode2......Off If No Signal, Off If No Operation, and Power
Save Mode are set to Off. These settings can be
changed.
Even after being set, changes can be made using Operation
Mode, located in the menu of the monitor. (See page 33.)
Power LED POWER button
Status of the monitor
Power on
Power off (Standby state*)