Protecting The Environment; Troubleshooting; Maintenance - Black & Decker BCD002 User Manual

Hide thumbs Also See for BCD002:

Original instructions manual (100 pages)

Table Of Contents

Table of Contents

ENGLISH

Minimize stalling on breakthrough by reducing pressure

and slowly drilling through the last part of the hole.

Keep the motor running while pulling the bit out of a drilled

hole. This will help reduce jamming.

Make sure switch turns drill on and off.

Drilling in wood

Holes in wood can be made with the same twist drill bits used

for metal or with spade bits. These bits should be sharp and

should be pulled out frequently when drilling to clear chips

from the flutes.

Drilling in metal

Use a cutting lubricant when drilling metals. The exceptions

are cast iron and brass which should be drilled dry. The cutting

lubricants that work best are sulfurized cutting oil or lard oil.

Screwdriving

Always use the correct type and size of screwdriver bit.

If screws are difficult to tighten, try applying a small

amount of washing liquid or soap as a lubricant.

Always hold the tool and screwdriver bit in a straight line

with the screw

Troubleshooting

Problem

Possible cause

Unit will not start.

Battery pack not

charged.

Battery pack will not

Charger not plugged

charge.

in.

Surrounding air

temperature too hot or

too cold.

Unit shuts off

Battery pack has

abruptly.

reached its maximum

thermal limit.

Out of charge. (To

maximize the life of

the battery pack it is

designed to shutoff

abruptly when the

charge is depleted

Maintenance

Your BLACK+DECKER tool has been designed to operate

over a long period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon proper tool

care and regular cleaning.

Your charger does not require any maintenance apart from

regular cleaning.

(Original instructions)

Possible solution

Check battery pack charg-

ing requirements

Plug charger into a work-

ing outlet.

Move charger and battery

pack to a surrounding air

temperature of above 40

degrees F (45ºC) or below

105 degrees F (+40.5ºC)

Allow battery pack to cool

down.

Place on charger

and allow to charge.

Warning! Before performing any maintenance on the tool,

remove the battery from the tool. Unplug the charger before

cleaning it.

Regularly clean the ventilation slots in your tool and

charger using a soft brush or dry cloth.

Regularly clean the motor housing using a damp cloth.

Do not use any abrasive or solvent-based cleaner.

Regularly open the chuck and tap it to remove any dust

from the interior.