Mitsubishi Electric MSZ-AP15VG-E1 Service Manual page 42

OPERATING PROCEDURE
6. Removing the indoor fan motor and the line flow fan
(1) Remove the panel (refer to section 1) and the corner
box.
(2) Remove the SW holder, the display P.C. board holder,
the electrical box (refer to section 3) and the nozzle
assembly (refer to section 4).
(3) Remove the screws fixing the motor bed. (Photo 8)
(4) Loosen the screw fixing the line flow fan. (Photo 9)
(5) Push the upper part of the water cover and unhook
the catch.
(6) Pull the water cover to the right to remove it.
(7) Remove the motor bed together with fan motor and
motor band.
(8) Release the hooks of the motor band. Remove the
motor band. Pull out the indoor fan motor.
(9) Remove the screws fixing the left side of the heat
exchanger. (Photo 10)
(10) Lift the heat exchanger, and pull out the line flow fan
to the lower-left.
* When attaching the line flow fan, screw the line flow
fan so 5 mm gap is provided between the right end
of the line flow fan and the right wall of the air pas-
sage of the box (Figure 1).
Figure 1
5 mm
OBH838B
PHOTOS/FIGURES
Photo 8
Catches of the water cover
Photo 9
Photo 10
Screws of the
left side of the
heat exchanger
42
Motor band
Screws of the
motor bed
Screw of the
line flow fan