Advertisement
Available languages
Available languages
ENGLISH (Original instructions)
1.
Wing bolt
2.
Base
3.
Switch trigger
4.
Lock button/Lock-off button
5.
Wrench
SPECIFICATIONS
Max. diamond wheel thickness
Rated speed (n)/No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
Intended use
The tool is intended for cutting in brick, concrete and
stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
4
Explanation of general view
6.
Hex wrench
7.
Outer flange
8.
Diamond wheel
9.
Inner flange
10. Hex bolt
Model
Blade diameter
Hole diameter
Max. cutting capacity
Overall length
Net weight
Safety class
END202-8
ENE023-2
ENF002-2
GEA005-3
)
0
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock.
11. Water cock
12. Water pipe
13. Limit mark
14. Screwdriver
15. Brush holder cap
4100NH3
110 mm
20 mm
2.0 mm
32 mm
-1
13,000 min
227 mm
2.9 kg
/II
Advertisement
