Bernina 380 Manual page 16

Preparation - Sewing
14
Needle Threader
A
B
1
A
3
Threading the Upper Thread
A
B
1 Press lever down
█
█
█
█
2 Guide thread to front of the needle
█
C
2
3 Release lever and thread
█
█
█
Attaching the thread spool
█
█
█
█
█
█
█
█
█
D
█
C
E
F
033301.71.04_2014-02_Manual_B330_B350_PE_B380_EN
raise needle
lower the presser foot
hold thread to the left and back
press lever A down and simultaneously guide the thread around hook B to
the right to the needle
put the thread from the front into the guide C until it catches in the wire
hook
release lever A and thread
put the thread under the foot and pull the thread backwards or
put the thread under the foot and pull it from front to back over the thread
cutter on left side of the head frame
raise the needle and presser foot
power switch to «0» (off)
place foam pad on pin base
place spool on pin (thread unwinds clockwise)
attach appropriate spool disc - diameter of spool determines disc size, there
must be no clearance between the disc and the spool
take thread through rear guide A
then into slit of upper thread tension B
pull thread down to the right of the take-up cover and around C
take thread up to the left of the cover and around D, placing it in the
take-up lever
take thread down and through guides E and F