GE AKW10 Series Owner's Manual And Installation Instructions page 10

PREPARE THE WINDOW
4
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
INSTALL THE AIR CONDITIONER
5
IN THE WINDOW
A
Place the air conditioner on the sill with
the bottom mounting rail against its back
edge. Center it and close the window
securely behind the top mounting rail.
It should be level or slightly tilted to the
outside. Use a level; about a 1/3 bubble
will be the correct case slant to the outside.
3 Screws
2 Frame locking brackets
B
Extend the left and right accordion panels
to the vertical window sashes and attach
3 Type B screws through the holes in the
upper panels, as appropriate.
Install the frame locking brackets between
C
the bottom of the accordion panel and the
window sill. Attach with 2 Type B screws.
NOTE: To prevent the window sill from
splitting, drive the pilot holes before
driving the screws.
Installation Instructions
10
6 INSTALL SUPPORT BRACKET AND
FOAM TOP WINDOW GASKET
CAUTION:
A
To prevent broken glass
or damage to windows,
on vinyl or other
similarly constructed
windows, attach the
window locking bracket
to the window side jamb.
Attach the window
locking bracket with one
Type B screw.
B Cut the foam top window gasket to the
window width.
Stuff the foam
C
between the
glass and the
window to
prevent air and
insects from
getting into the room.
NOTE: If the gasket supplied does not fit
your window, obtain appropriate material
locally to provide a proper installation seal.
Vinyl
Wood