Replacing The Generator Tubes - NewAire HO3 2500 User Manual

Maintenance is required on the ozone generator about every six months depending on the amount of use and/or if the
ozone output is low or the ozone generator 1 Amp fuse has blown.
WITH THE UNIT UNPLUGGED, place the Hydroxyl
u
Ozone Generator vertically with the controls facing
up and remove the two retaining screws as shown,
one on each side of the plastic end cap. Repeat for
other end cap.
Remove five countersunk Phillips head machine
v
screws, located on each side of upper cabinet and
one placed between handle and control panel. Lift
upper cabinet cover clear of the machine.

Replacing the Generator Tubes

Remove two screws (one on each generator tube).
w
Loosen (do not remove) the screw in the middle of
the tubes holding the titanium electrode to the wire
assembly.
Remove ozone generator tube and electrode. Gently
x
remove dust and particulate build up from around
the generator assembly.
— 13 —