Blender Quick Reference Guides; Cleaning And Maintenance; Food Processor - Cuisinart SmartPower Duet BFP-703 Series Instruction Booklet

QUICK REFERENCE GUIDE
FOR BLENDER FUNCTION
To activate blender
To begin blending
To change speeds
To pulse
To crush ice
To stop blending and deactivate blender
To stop blending in Pulse or Ice Crush mode
To stop blending in Stir, Chop, Mix, Purée, or
Food Processor mode
SPEED SELECTION GUIDE
FOR BLENDER FUNCTION
Refer to this guide to choose the best speed for your desired result.
Ingredient/Recipe Speed
Reconstituting frozen orange Stir
juice concentrate
Mayonnaise Stir
Salad dressings Stir
Nuts Chop
Whipping cream Mix
Bread crumbs Mix
Grating citrus zest Purée
Milk shakes Purée
Baby food Purée
Health drinks

Food Processor

Frozen cocktails Food Processor
Grinding hard cheese Food Processor
Spices Food Processor
Ice Ice Crush
Press On- The blender is in On mode.
Press desired speed button
Press desired speed button.
In On mode press Pulse, then press and
release desired speed button as needed.
In On mode, press and release Ice Crush
button as needed.
Press Off button.
Release button.
Press speed button again. This will return
the blender to On mode. Press Off button
to turn blender off.
Result
Smooth and full-bodied
Thick and creamy
Desired consistency
Coarse to fine
Thick topping
Uniformly fine
Uniformly fine
Smooth and creamy
Smooth and creamy
Smooth and creamy
Thick and slushy
Coarse to fine
Coarse to fine
Snowy

CLEANING AND MAINTENANCE

Always unplug your Cuisinart SmartPower Duet
®
electrical outlet before cleaning. The blender is made of corrosion-resistant parts that
are easy to clean. Before first use and after every use, clean each part thoroughly.
Periodically check all parts before reassembly. If any part is damaged or blender jar is
chipped or cracked, DO NOT USE BLENDER.
Remove the blender jar from the motor base by lifting straight up and away. Twist off
the locking ring by turning counterclockwise. Remove the cutting assembly and
rubber gasket. Wash in warm soapy water; rinse and dry thoroughly. Place the locking
ring in the upper rack of the dishwasher or wash in warm water.
CAUTION: Handle the cutting assembly carefully. It is SHARP and may cause injury.
Do not attempt to remove blades from cutting assembly.
Remove the blender jar cover and the measured pour lid. Wash in warm, soapy water;
rinse and dry thoroughly, or place in the upper rack of the dishwasher. The blender jar
should be washed in warm soapy water and rinsed and dried thoroughly. The blender
jar can also be placed upside down in the dishwasher.
Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry
thoroughly. Never submerge the motor base in water or other liquid, or place in the
dishwasher.
Any other servicing should be performed by an authorized service representative.
Tip: You may wish to clean your blender cutting assembly as follows: Squirt a small
amount of dishwashing liquid into assembled blender jar and fill halfway with warm
water. Run on Stir for 15 seconds. Repeat using clean tap water. Empty blender jar
and carefully disassemble parts. Wash cutting assembly, gasket and locking ring in
warm, soapy water. Rinse and dry all parts thoroughly.
7
Blender/Food Processor from the
®