Hitachi VZC40FHD5300 Owner's Manual page 47

DVD Mode (Cont.)
DVD Menus
The DVD player function of this TV set contains different settings menus where you
can program your preferred settings. Once you have programmed any settings, the
unit will retain them in its memory until you change them, even when switching the
unit to standby mode. This means you can always operate the system under the same
conditions.
Menu Navigation
• Press the D.SETUP button on the remote control.
• Use the / / /
the setup page where you can adjust values.
• Use the / / /
• Press the D.SETUP button again to close the setup menu.
• Use the / buttons to switch to another main setup item. Then press the
button to enter the submenu page.
• Press the button to return to the previous menu page.
General Setup Page
TV Display: This setting is for selecting
the TV output mode. Available options:
Normal/PS (Pan & Scan mode), Normal/
LB (Letter Box mode),
Wide: 16:9 (Wide Screen mode).
OSD Language: This is for choosing
your desired OSD language.
Screen Saver: Set to ON, a screen saver
will appear if the unit is left idle and no operation is carried out for five minutes.
Last Memory: Enter another input source (except USB) during disc playback, and
then back to DVD input source again, this unit will resume playback from the point
where last playback was stopped, if Last Memory is set to ON.
After Sales Support
Telephone:
Email:
buttons to select the preferred item, then press OK to display
buttons to adjust the item, then press OK to confirm the setting.
1300 886 649
info@tempo.org
or OK
47