LG LD-2120W Owner's Manual page 8

INSTALLATION INSTRUCTIONS
Step 6 :
WATER SUPPLY CONNECTION
1
Connect the water supply hose to the
valve behind dishwasher and the water
tap as shown in figure.
This dishwasher may be fed with either
hot or cold water. If the water can not be
maintained below 65ºC, the dishwasher
must be connected to cold water.
2
When connecting, the sealing tape or
sealing compound should be used to
avoid water leaks. Make sure that the
line is not kinked or sharply bent.
Valve
Step 7 :
FINAL CHECK AND ASSEMBLING
1 Securely hand tighten supply hose to
water supply.
Plug power supply cord into an
earthed the power plug and switch on.
2
After installing the product, operate
the dishwasher through one cycle
(Quick cycle is recommended) without
loading the dishes.
Through this, you can check for water
leak and operating conditions.
When you operate the product the
first, the noise may be occurred.
In that case, turn off power switch and
restart the dishwasher.
Water tap
Water supply
hose
Step 8 :
HOW TO LEVEL THE PRODUCT
After installing the product, if you feel some
sticky or hear a frictional sound between the
side portion of door and tub when you open or
close the door, you have to adjust the level of
product.
Case 1. In case the door is slanted to the right
Fig. C
• If the door is slanted to the right as shown in
figure C, repeat the procedure shown as below
until the door is operated normally.
1) Unscrew(counter-clockwise) the left leg of
back side and high the level.
2) Check the opening of door if there still
remains sticky or friction sound.
• When the product is correctly leveled, There
should be no slant , stickiness or friction sound.
Case 2. In case the door is slanted to the left
Fig. D
• If the door is slanted to the left as shown in
figure D, repeat the procedure shown as below
until the door is operated normally.
1) Unscrew(counter-clockwise) the right leg of
back side and high the level.
2) Check the opening of door if there still
remains sticky or friction sound.
• When the product is correctly leveled, There
should be no slant , stickiness or friction sound.
8