Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Step 5 :
DRAIN LINE CONNECTION
1
If the end of drain hose does not fit to
the drain line, use a piece of rubber
connector(not supplied) that must be
resistant to heat and detergent and may
be obtained from a plumbing shop.
There are 2 typical connections as
2
shown in Figure A, B.
The "S" trap spigot must be drilled out
cleanly and free of obstruction to its
maximum internal diameter, if used for
drainage.
To prevent siphoning, one of the following
instruction methods must be followed:
■ When the drain hose is connected to a
sink "s" trap or waste disposal unit, the
hose must be looped up to the underside
of the bench top and secured.
Fig. A
■ When the drain hose is connected to a
separate stand pipe, it is essential that an
air tight connection is made.
Refer to Fig.B
Fig. B : Drainage connection - stand pipe.
Drain Hose Extension
Extend Drain Hose as shown below.
When you connect or extend Drain Hose,
make sure that drain hose is not kinked.
(Bends should have 40 mm radius.)
7
CAUTION
Advertisement
Table of Contents
