Advertisement
Instruction Manual
Bed Frame For Twin Mattress
Model AP-11
Due to the presence of small parts during assembly, keep
out of reach of children until assembly is complete.
Model AP-11 Airplane Bed Frame
Read all instructions before assembly and use.
Keep instructions for future use.
ADULT ASSEMBLY REQUIRED
Lancaster, PA 17601
tradecraftspecialties@gmail.com
www.tradecraftspecialties.com
Revised 08/21/2017
1900 Alfa Drive
(717) 269-8934
Page
1 of 8
Advertisement
Table of Contents
Related Manuals for Tradecraft Specialties AP-11
Summary of Contents for Tradecraft Specialties AP-11
- Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 1 of 8...
- Page 2 Please verify that you or your child does not have an allergy to linseed oil before using this product. General Specifications Assembled dimensions (approximate): 89" long, 39.5" wide, 39" high. Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 2 of 8...
- Page 3 We use low-odor, zero VOC paint where possible and do our best to keep unpleasant odors to a minium. Disassembly T o disassemble, reverse order of steps for assembly. Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 3 of 8...
- Page 4 Parts List Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 4 of 8...
- Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 5 of 8...
- Page 6 (1) screw at each end of support bar. Make sure support bar end is tight and perpendicular with side of bed. Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 6 of 8...
- Page 7 Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 7 of 8...
- Page 8 Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model AP-11 Airplane Bed Frame Revised 08/21/2017 8 of 8...
Need help?
Do you have a question about the AP-11 and is the answer not in the manual?
Questions and answers