Tradecraft Specialties AP-10 Instruction Manual

Bed frame for twin mattress

Advertisement

Instruction Manual
Bed Frame For Twin Mattress
Model AP-10
Due to the presence of small parts during assembly, keep
out of reach of children until assembly is complete.
Model AP-10 Propeller Airplane Bed Frame
Read all instructions before assembly and use.
Keep instructions for future use.
ADULT ASSEMBLY REQUIRED
Lancaster, PA 17601
tradecraftspecialties@gmail.com
www.tradecraftspecialties.com
Revised 07/31/2016
1900 Alfa Drive
(717) 269-8934
Page
1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AP-10 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tradecraft Specialties AP-10

  • Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 1 of 6...
  • Page 2 Please verify that you or your child does not have an allergy to linseed oil before using this product. General Specifications Assembled dimensions (approximate): 80" long, 39.5" wide, 24" high. Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 2 of 6...
  • Page 3 The smell should completely dissipate within several days. The smell may be stronger on products with areas of exposed unpainted material. Disassembly To disassemble, reverse order of steps for assembly. Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 3 of 6...
  • Page 4 Parts List Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 4 of 6...
  • Page 5 (1) screw at each end of support bar. Make sure support bar end is tight and perpendicular with side of bed. Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 5 of 6...
  • Page 6 Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model AP-10 Propeller Airplane Bed Frame Revised 07/31/2016 6 of 6...

Table of Contents