How To Upgrade Full Image Remotely; Wizard Commands - Draytek Vigor VigorAccess Quick Start Manual

How to Upgrade Full Image Remotely

Users can use the following command to remotely upgrade full image. Make sure you have prepared
TFTP server, vendor supplied TEImage.bin.gz, and put TEImage.bin.gz into root directory of TFTP
server. The commands are listed as below.
Command
$reboot config safe
$create ethernet intf ifname eth-0 ip <ip_address> mask <mask>
$download src TEImage.bin.gz dest /nvram/TEImage.bin ip <server_ip>
(or $download src TEImage.bin.gz dest /nvram/image/ ip <server_ip> for version 2.10.x and
onwards)
Downloading the File.
...........................................................
Download file size is 1991180
Check if TEImage.bin shall uncompress
Uncompressing "TEImage.bin.gz" (11990111->4194304)......
TEImage.bin.gz is in proper format
Unlocking Flash........
Unlock successful
Erasing Flash ........................................
Erasing successful
Starting to Uncompress TEImage.bin.gz and Burn Flash
Uncompressing "TEImage.bin.gz" (1990111->4194304)......
#########################
Flash Programmed successfully
Done.
Download session Completed, Bytes received 1991180...
$
$reboot

Wizard Commands

In addition to the primitive commands described as above. Several wizard commands are provided which
is used easily. Type wizard to see the command syntax.
Command
$ wizard
<List of Wizard Commands>
---------------------------------------------------------------
dsl show [fast]
alarm show
pvc show
pvc create <dsl: 1~24> <vc: 1~8> <vpi> <vci> [<llcmux|vcmux>] [<interleaved|fast>]
pvc delete <dsl: 1~24> <vc: 1~8>
bridge delete <bridge id: 1~193>
tca show <acked>
critical show <acked>
firmware upgrade [-]<source file> <CP|DP|FD|DSL> <server ip>
fd show
port <disable|enable|restart> <dsl: 1~24>
config backup <filename> <server ip>
config restore <filename> <server ip>
---------------------------------------------------------
dsl show [fast]
firmware upgrade
config backup/restore
14
Description
Reboot from Safe mode
Reboot from Default mode
Description
Display all the 24 ports DSL status
Upgrade firmware without removing the existing one
in advance
Backup or restore the current configuration
Quick Start Guide for VigorAccess