Timer Setting - Mitsubishi Electric Fresh Master GUF-100RDH3 Operating Instructions Manual

• The setting advances one minute every time the
pressed, and goes back one minute every time the
pressed.
When respective /
time display goes fast forward. It advances in the order of 1 minute
digit - 10 minute digit - one hour digit.
• About 10 seconds after the button operation has been completed,
the "current time" and "time" displays disappear.
Caution:
• The Remote controller is equipped with a simplified clock with
a precision of about + or - one minute per month.
• The time must be readjusted (reset) every time the Fresh Mas-
ter is subjected to a power stop or a power failure.

3.2.7. Timer setting

• If the timer is set, the unit starts (stops) at the set time, and the time
mode is terminated.
• When you wish to confirm the starting and ending time, press the
[time selection] button while [timer] is displayed.
Function of timer
On-timer
Set the on-timer for the time the working day begins in your company.
When the set start time arrives, the Fresh Master starts operation.
Off-timer
Use the off-timer as a reminder to turn off the Fresh Master. When the
set end-work time arrives, the Fresh Master stops operation.
There are three methods for using the timer.
1. ON/OFF Timer When setting both starting and ending time
2. On-timer When only setting the starting time
(Ending time is set to "__ : __ ")
3. Off-timer When only setting the ending time
(Starting time is set to "__ : __ ")
Display example of timer setting
The example shows a timer set for operation start at 8:00 and end at 17:00.
[Timer] display
[Timer] button
[Time selection] button
PAR-F27MEA
button is
button is
buttons are pressed continuously, the
ON OFF
ON OFF
[Starting/ending time] display
OFF
˚C
CLOCK
˚C
TEMP.
ON/OFF
FILTER
CLOCK→ON→OFF
CHECK TEST
TIMER SET
[Time setting] button
1 Press the [timer] button and erase the "timer" display
2 Press the [time selection] button and bring up the "starting
time" display
3 Press the ( ) button of the [time setting] and set the
starting time
When using it as an off-timer, set the starting time to "__ : __ ".
The "__ : __ " is displayed next to the time i.e. 23:50.
4 Press the [time selection] button and bring up the "ending time"
display
5 Press the ( ) button of the [time setting] and set the
ending time
When using it as an on-timer, set the ending time to "__ : __ ".
The "__ : __ " is displayed next to the time i.e. 23:50.
6 Press the [timer] button and bring up the "timer" display
Bringing up the [timer] display completes the setting.
Every time the ( ) button of the [timer setting] is pressed
once, it advances (or goes back) by 10 minutes.
If the button is pressed continuously, it advances (or goes back) con-
tinuously.
First set the hour digit and then set the minute digit.
When the ON/OFF timer mode is set, you can run (on-timer) or stop
(off-timer) operation by pressing the [ON/OFF] button even when there
is remaining time.
Release
Press the [timer] button and erase the "timer" display.
9