Passive Speakers; Active Speakers - LD SUB Series User Manual

OPERATING INSTRUCTIONS:

PASSIVE SPEAKERS

SAT42G2(W) and SAT62G2(W)
Up to four SAT42G2(W) or SAT62G2(W) speakers per power amplifier output can be operated in parallel at 4
ohms. The speaker signal is simply looped through to the next speaker via the connector panel on the rear.
SAT242G2(W) and SAT82G2(W)
Up to two SAT42G2(W) or SAT62G2(W) speakers per power amplifier output can be operated in parallel at 4
ohms. The speaker signal is simply looped through to the next speaker via the connector panel on the rear.
SUB88 in conjunction with SAT42G2(W), SAT62G2(W), SAT242G2(W) or SAT82G2(W)
Connect the speaker cables from the power amplifier (Output Left and Right) to the Input Left and Right
connectors of the subwoofer.
Afterwards, connect the SAT Series speakers to the Output Left and Right connectors of the subwoofer.
Up to two SAT42G2(W) or SAT62G2(W) speakers per subwoofer output (Output Left and Right) can be operated in
parallel at 4 ohms.
One SAT242G2(W) or SAT82G2(W) speaker per subwoofer output (Output Left and Right) can be operated in this
configuration at 4 ohms.
We recommend using speaker cable with a conductor cross-section of at least 2 x 1.5 mm².

ACTIVE SPEAKERS

It is advisable to always turn on active speakers last and turn them off first in order to avoid the
switch-on noises caused by connected mixers, etc. If multiple active speakers are
connected one after the other in series (SAT62AG2), then they should always be switched on in the order in
which they are connected and switched off in reverse order.
Turn the active speakers off before you connect them. They can be connected both via 6.3 mm
TRS plugs (balanced three-pole / unbalanced two-pole) as well as balanced three-pole XLR plugs
. Once you have connected all of the necessary cables and set the volume (MAIN LEVEL) of the active speaker to
minimum, you can switch on the audio source (e.g., mixer). Afterwards you can also switch on the active spea-
kers. Start an audio signal and now turn the MAIN LEVEL knob clockwise until the desired volume is attained.
Carry out these steps with all connected active speakers.
On the following pages of this user manual, you will find a summary of the connectors, controls, and indicators.
6