Installation - Zokop YPO2-09C User Manual

1. Control panel
2. Horizontal louvre
3. Vertical louvre
4. Air outlet frame
5. Vertical Louvre connecting lever
6. Caster
7. Horizontal louvre connecting lever
8. Main vertical louver
9. Front shell
10. Handle position (right side: remote control storage area)
11. Back shell
12. C shape bucke of the heat
exhaust hose snap
13. Power cord

1. Installation

Warning: leave this mobile air-conditioner in an upright position for at least 2
hours before first use.
This air-conditioner may be moved indoor conveniently; leave the air-conditioner in an
upright position while moving it. The air-conditioner shall be placed on a flat ground surface.
Do not install or operate this air-conditioner in a bathroom or other wet environments.
1.1. Assembly of the heat exhaust hose and heat exhaust hose short connector (as shown in
Figure 1)
1). Take out the heat exhaust hose short connector and heat exhaust hose, and remove the
plastic bag.
2). Pull the few turns at the end of the heat exhaust hose apart, screw the round end of the
heat exhaust hose short connector counterclockwise into the heat exhaust hose to form
the heat exhaust hose assembly (as shown in Figure 2).
Note: 1. The heat exhaust hose and heat exhaust hose short connector shall be
screwed into place and the heat exhaust hose shall be screwed in at least 3 turns.
23
Installation Adjustment
Figure 1
24
25
14. Lower air duct bottom
15. Wire-winding post
16. Drain cap
17. Evaporator filter mesh
18. Evaporator filter frame
19. Radiating fine mesh
20. Condenser filter mesh
21. Condenser filter frame
22. Base plate
24. Heat exhaust hose short connector
25. Heat exhaust hose
26. Window sealing board assembly
26
23. Remote control
Figure 2
Page: 5/17