Handling Of The Unit - Zokop YPO2-09C User Manual

2.2 Installation of the filter frame and filter mesh
Special note: be sure to install the filter mesh first and then install the filter frame.
1）To install the evaporator filter mesh and condenser filter mesh, point the back end of the filter
mesh toward the socket and then push the filter mesh evenly and gently into the socket.
Note: 1. Install the filter mesh in the reverse order of removal. The filter mesh must be
installed into place; otherwise, the filter frame may not be installed into place.
2. Install the filter mesh gently so as not to damage it.
2). To install the evaporator filter frame and condenser filter frame, point the back end of the
filter frame toward the socket and then push the filter frame evenly and gently into the
socket.
Note: 1. Install the filter frame in the reverse order of removal. Be sure to install the filter
mesh first before the filter frame is installed.
2. Install the filter frame gently so as not to damage it
3. Cleaning of the handle position and remote control storage area
1). Take the remote control out of the remote control storage area in the direction shown by
the arrow; (as shown in Figure 15)
2). Clean the handle position and remote control storage area of this unit with wringed wet soft
cloth;
Note: the wet soft cloth must be wringed out. Do not drip water into the unit.
3). If the remote control needs to be put back into the remote control storage area, put it back
into the storage area in the reverse direction of removal.
1. Handling and moving of the unit
1). To handle or move the unit, hold the top of the air outlet of the front shell with one hand
and the handle position at the top of the back shell with another hand, and leave the unit in
the upright position. (As shown in Figure 16).
Note: 1. Do not hold the horizontal louvre by hand.
Figure 14
Remote control
Figure 15

Handling of the Unit

Remote control storage area
Page: 14/17