Technical Information; Environment Concerns - Atag VA63111LT User Manual

26
If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase
or with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi deter-
gent tablets.
Refer to 'HINTS AND TIPS' for other
possible causes.

TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water
supply to decrease energy consumption.

ENVIRONMENT CONCERNS

Recycle the materials with the symbol
Put the packaging in applicable containers
to recycle it.
How to activate the rinse aid
dispenser
1. Press the on/off button to activate the
2. Press and hold, at the same time, but-
3.
4.
5. Press the on/off button to deactivate the
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
. Help protect the environment and human
health and to recycle waste of electrical and
electronic appliances. Do not dispose
appliance. Make sure that the appliance
is in setting mode, refer to "Setting and
starting a programme".
ton and button
tors of buttons
start to flash.
Press button .
• The indicators of buttons
go off.
•
The indicator of button
to flash.
• The indicator
Press button . The indicator
comes on. The rinse aid dispenser is
activated.
appliance and to confirm the setting.
2)
until the indica-
, and
and
continues
is off.
596 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12
0.10 W
0.10 W