Positioning The Tension Pole - JVC HR-DVS2EK Service Manual

2.17

POSITIONING THE TENSION POLE

See Fig. 2-17-1.
Tension Arm Sub
Assembly
D section
Adjustment Method
Note:
• Remove the cassette housing assembly in advance.
1. Set the mechanism mode to the PLAY mode. (See pages
2-20 and 21.)
2. Loosen a screw A .
3. Check the location of the tip (section B ) of the tension
arm assembly to make sure that it is within area C .
If it is located outside, turn part D to bring it within the
specified area.
4. Tighten the screw A .
Note : Tightening torque for the screw A : 0.06 Nm (0.6
kgfcm)
B section
C
Screw A
Fig. 2-17-1
2-39