Installation; Installing Batteries; Connecting The Telephone - ClearSounds Talk500 User Manual

Talking telephone featuring ultraclear sound shaping technology
Hide thumbs Also See for Talk500:
Table of Contents

Advertisement

Available languages

Available languages

on top of a TV or VCR; and, if interference is experienced, moving
the cordless telephone farther away from the TV or VCR will often
reduce or eliminate the interference. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.
Your telephone requires four AA batteries (not supplied) in case of
network power failure for LCD backup & operations. When
on the display or the display dims, replace the batteries with 4 AA
fresh ones. Note: Should you choose not to install batteries - the
telephone numbers in memory and the voice recordings are stored
in non-volatile flash memory and will not be lost.
1.
Before opening the battery compartment, make sure the telephone
is disconnected from the telephone line and the power supply.
2. Use a flat-blade screwdriver to lift the battery compartment
door.
3. Insert 4 AA batteries into the compartment as indicated by the
polarity symbols. Never mix battery types (different chemistries,
brands and/or fresh vs. used).
4. Snap the battery compartment door back into place.
1. plug one end of the telephone line cord into the TEL.LINE jack at
the back of the telephone base.
2. plug the other end of the telephone line cord into the wall outlet.
3. plug one end of the coil cord into the handset's modular jack.
4. plug the other end of the coil cord into the left side of the
telephone base.

INSTALLATION

Installing Batteries

Connecting The Telephone

5 – ENGLISH
appears

Advertisement

Table of Contents
loading

This manual is also suitable for:

V508

Table of Contents