Connection With The Mains; Operation - EuroLite N-200 User Manual

Table of Contents

Advertisement

Available languages

Available languages

The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green Earth
Attention! The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

Switch the device on via the power switch.
After a certain warm-up time, the device is ready to operate. Then the stand-by lamp of the remote control
lights up. By operating the smoke switch on the remote control the smoke emission starts. It may happen
that the stand-by lamp turns off and the smoke emission stops. In this case the device is heating up again
and will be ready to operate in approx. 1-2 min. This process guarantees an appropriate vaporization
temperature and the best smoke emission possible. The temperature is regulated by a high quality
thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DANGER TO LIFE!
International
L
N
16/18
00096813.DOC, Version 1.0

Advertisement

Table of Contents
loading

Table of Contents