Starting Operation; Installation; Connection With The Mains - EuroLite NSF-150B DMX User Manual

4 5
1: Ground
2: Signal (-)
3: Signal (+)
7
Remote
ON
8
OFF
9
DMX Address
Fuse: F 8 A, 250 V
10
DMX Indicator
Power supply:
230 V AC, 50 Hz ~
11

STARTING OPERATION

Install the device on a plane surface.
The fluid tank of the device needs to be filled with smoke fluid before starting up operation and always
disconnected from the mains as fluid could be spilled.
Only use quality smoke fluids available at your dealer. We recommend high-quality Eurolite smoke fluids (e.
g. Eurolite Smoke Fluid "P" professional, 5 l). You must not use substances that are classified as "dangerous
working material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.

Installation

Install the device in a well-ventilated area. The operation in an unsufficiently ventilated room can lead to a
condensation of the smoke fluid. The resulting slippery surface can cause accidents. Keep a minimum
distance of 20 cm around and above the device.
Furthermore do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
Only install the smoke-machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15° .
This device is constructed for a standing installation only.

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
Attention! The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
6
Full
ACHTUNG!
Vor Gebrauch Anleitung lesen.
Gebrauch befindliche Geräte müssen allpolig spannungsfrei geschaltet
werden. Im Geräteinnern befinden sich keine zu wartenden Teile. Wartungs-
und Servicearbeiten nur durch autorisierten Fachhandel.
Gerätes Netzstecker ziehen.
CAUTION!
Read user manual before use.
must be disconnected from the mains.
the device. Maintenance and service operations only by authorized dealers.
Before opening the housing disconnect from mains.
Type: NSF-150B DMX Spray Fogger
Power supply: 230 V AC, 50 Hz ~
Power consumption: 1450 W/1500 VA
Fuse: F 8 A, 250 V
Empty Year of construction: 2012
13 14
12
International
L
N
Gerät vor Feuchtigkeit schützen. Nicht im
Vor Öffnen des
Keep away from moisture. Unused machines
There are no serviceable parts inside
®
eurolite
www.eurolite.de
MADE IN CHINA
13/16
(4) DMX Out
(5) Housing
(6) Fluid tank
(7) DMX In
(8) Power switch
(9) Fuseholder
(10) Power supply
(11) DIP switches
(12) DMX indicator
(13) Remote control socket
(14) Fluid level display
00064957.DOC, Version 1.1