Canon LV-8320 User Manual page 56

Setting
Lamp mode
Lamp mode
This function allows you to change brightness of
the screen.
Auto.......Brightness according to the input
signal.
Normal..Normal brightness
Eco 1.....70%-80% of the normal brightness.
Eco 2.....50% of the normal brightness.
Lamp life control
Select the lamp operation when the total lighting
time of a lamp exceeds the recommended total
hours of use.
Mode 1........ The lamp can be turned on even
after exceeding the recommended
total hours of use.
Mode 2.........The lamp can be turned on even
after exceeding the recommended
total hours of use. But the projector
turns off automatically after 3
minutes.
Note:
• Lamp mode can not be changed for a while after turning on the projector. Lamp needs some time to stabilize after
the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
• If Mode 2 has been selected and the projection lamp exceeds the recommended total hours of use, the
replacement icon will be displayed at the time of power-on. Then the projector will turn off after 3 minutes.
Lamp replacement icon
• The Lamp replacement icon will not appear when the Display function is set to Off (p.48), during Freeze (p.27), or
Blank (p.28).
Remote control
This projector provides two different remote
control codes: the factory-set initial code (Code 1)
and the secondary code (Code 2). This switching
function prevents remote controller interference
when operating several projectors or video
equipment at the same time.
When operating the projector in Code 2, both
the projector and the remote controller must be
switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting
Menu.
To change the code for the remote controller:
Press and hold both the MENU and IMAGE
buttons together for 5 seconds or more. After
changing the code, make sure the remote
controller operates properly.
Note:
• When different codes are set on the projector and on the remote controller, any operation cannot be made. In that
case, switch the code on the remote controller to fit the code on the projector.
• If the batteries are removed from the remote controller for a long period of time, the remote control code will be
reset.
56
Lamo mode
Remote control