Canon LV-8320 User Manual page 54

Setting
Standby mode
This function is available when operating the
projector via network.
Network .. Supply the power to the network
function even after turning off the
projector by pressing the POWER
button on the remote controller.
You can turn on/off the projector
via network, modify network
environment, and receive an
e-mail about projector status while
the projector is powered off.
Eco ......... Select Eco when you do not use
the projector via network. The
projector's network function will
stop when turning off the projector.
Refer to the user's manual of "Network Set-up
and Operation".
Note:
When selecting Network, the cooling fans may
be running depending on the temperature inside
the projector even if the projector is turned off.
P-timer
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
Count up ....... The P-timer display 000:00
appears on the screen and the
count up starts (000:00-180:00)
Count down .. The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer ............. Use the Point ▲▼ buttons to set
the Timer (1-180 Min). Timer is
available in Count down only.
Factory default value is 10 Min.
Start ............... It executes the count up or count
down function. Press the OK
button at Start and the indication
changes into Stop. To stop
Count up or Count down, press
the OK button at Stop on the
screen menu, then the indication
changes into Restart. Press the
OK button at Restart to resume
Count up or Count down.
Reset ............. Reset the P-timer values.
Press the OK button at Reset
to return to the following value:
Count up ........ "000:00"
Count down ... Timer that
Exit ................ To exit the P-timer operation.
54
X: disabled
Serial command
Network
Monitor Out
Audio Out
Direct power on
*1 When Eco is selected, it is only possible to turn on the
projector while using the RS-232C serial port.
*2 When switch the Standby MIC out function On and in
Standby mode status, only MIC volume can be output.
P-TIMER
P-timer display
Stop or Cancel the P-timer via Remote controller
you set
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
O: enabled
*1
*2