Fujitsu FP-510II User Manual page 80

(4) Auto Reconnect Function
When the printer is in the pairing state with the high-order device equipped with iOS in
the Bluetooth interface, if the "BT AUTOCONNECT(iOS)" is set to enable, the
reconnection is performed automatically with the last high-order device equipped with
iOS connected from the printer when the following conditions occur.
- Communication recovers after disconnection of Bluetooth communication
- Power is turned ON after the printer power is turned Off
When the "BT AUTOCONNECT(iOS)" is set to disable, it is necessary to perform the
connection operation each time from the Bluetooth setting screen on the high-order
device equipped with iOS.
BT
AUTOCONNECT
(iOS)
ENABLE
DISABLE
(Factory shipment
settings)
Note that when connecting a printer with a high-order device not equipped with iOS,
the auto reconnect function becomes disabled even if "BT AUTOCONNECT(iOS)" is
set to enable.
How to use
This is an optimal setting when
always using one printer on one
high-order device equipped with iOS.
This is an optimal setting when
sharing one printer with multiple
high-order devices equipped with iOS.
79 / 125
Description
Reconnection after
communication is disconnected is
performed by the following
sequence.
1. The printer connects to the last
high-order device equipped with
iOS connected.
2. If the connection in 1 fails
(timeout), the printer waits for the
connection from the high-order
device equipped with iOS.
3. If the connection in 2 fails
(timeout), the printer reconnects
to the last high-order device
equipped with iOS connected.
4. During a connection failure,
the printer repeats 2 and 3.
The printer always waits for the
connection from the high-order
device equipped with iOS.