Juniper C Series Hardware Manual page 69

3.
Connecting to a Serial Console Using IPMI Serial over LAN (SOL)
IPMI SOL enables a remote user to monitor and manage a C Series Controller through
a serial console by means of an IPMI session. IPMI SOL redirects the C Series
Controller's serial port input and output over IP. To connect to a remote serial console
using IPMI SOL, the remote system must have IPMI configured. Only one IPMI SOL
connection is allowed per IPMI interface.
To connect to a serial host using IPMI SOL:
To exit from the current IPMI SOL session, enter
Disconnecting from a Serial Console Using IPMI Serial over LAN (SOL)
Only one IPMI SOL connection is allowed per IPMI interface. You can close the active
IPMI connection to a local host or to a remote host.
[edit system ipmi]
user@host# set user name plain-text-password
For example:
user@host#set user johndoe plain-text password
New password: xyz123 (text will not appear)
Re-type new password: xyz123 (text will not appear)
Verify the configuration.
[edit system ipmi]
admin@gnome# show
address 10.227.1.145/24;
gateway 10.227.7.1;
user admin {
encrypted-password ********;
}
user jdoe {
encrypted-password ********;
}
From operational mode, enter the
console.
user@host>ipmisol open host host user user
host IP address of remote host IPMI interface
user IPMI user name configured in the remote host
For example:
user@host>ipmisol open host 10.10.10.30 user johndoe
Connecting to a Serial Console Using IPMI Serial over LAN (SOL)
Chapter 9: Configuring IPMI on a C Series Controller (SRC CLI)
command to connect to a serial
ipmisol open
.
~
53