Operating The Device - Axion STIM-PRO X9 Plus Instruction Manual

AXION

OPERATING THE DEVICE

Power On/O button and intensity control
EN
The device can be switched on and o by pressing the On/
O button. The intensity can be reduced or increased by
pressing the intensity buttons. The intensity can be set per
channel from 0 to 100mA in steps of 1mA.
There are 4 LED lights at the top of the device. They shine
yellow to indicate activity of the corresponding channel.
Mode control
There are 5 TENS modes available (B,
N, M, SD1, SD2) and 3 EMS modes (C,
S, A) as well as the P mode (programs
1-37). The modes can be selected by
pressing the "MODE" button. If a TENS
mode is selected, the LCD display
shows "TENS". If an EMS mode is
selected, "EMS" is displayed.
Set control
By pressing the control, you may enter the setting you
intend to adjust. You may start to set the value by pressing
the or controls when the value is flashing.
Increment control
When pressing this button, the parameter will increase. This
button controls the increase of settings.
Decrement control
When pressing this button, the parameter will decrease.
This button controls the decrease of parameter.
50
© Copyright Gebrauchs.info