Related Manuals for MMM Group CO2Cell 190 Standard
Summary of Contents for MMM Group CO2Cell 190 Standard
- Page 1 Instructions for use INCUBATOR CO2Cell 190 Standard CO2Cell 190D Standard (with decontamination 160 °C) CELL Standard 190_np_en 1301_mmm_V1.02...
-
Page 3: Table Of Contents
CONTENTS: 24. 1. 2013 SAFETY ..............................3 ..........................3 EGAL CONSIDERATIONS ............................3 NTENDED USE ........................3 YMBOLS USED IN THIS MANUAL ......................... 3 ENERAL SAFETY INSTRUCTIONS DESCRIPTION .............................3 ............................4 ONSTRUCTION ..............................4 OORS ............................4 ONTROL SYSTEM ............................4 SENSOR ..............................4 IAGRAMS 2.5.1 ........................4 RONT AND INNER VIEWS .......................... - Page 4 ..11 ..........................MS VOLT FREE ALARM RELAY ..11 ............................... ULTI DOORS ACCESSORIES..........................12 CLEANING............................12 ............................12 UTER SURFACES ............................12 NNER SURFACES ......................12 XIDATION AT HIGH TEMPERATURE SERVICE............................12 10.1 ........................12 ARRANTY 10.2 ........................12 REVENTATIVE MAINTENANCE 10.3 ...........................12 ETURNING A UNIT DISPOSAL............................13 TECHNICAL INFORMATION........................13 12.1 ............................13 ECHNICAL DATA...
-
Page 5: Safety
Instructions for use These safety instructions are intended to be used alongside SAFETY any local safety guidelines, rules and regulations. If in organisation. LEGAL CONSIDERATIONS Only skilled electricians or engineers authorised by MMM It is important that you read this manual can perform repairs or maintenance on this incubator. -
Page 6: Construction
Instructions for use DIAGRAMS CONSTRUCTION The inner chamber is made from 304 grade stainless steel. 2.5.1 FRONT AND INNER VIEWS It is deep drawn from one piece with no welds and is electro-polished, meaning that the inner surfaces are smooth and easily cleaned. The removable shelves, racking and water tray are also made from stainless steel. -
Page 7: Delivery Transportation And Storage
Instructions for use STORAGE DELIVERY If the incubator has been in a cold location for a TRANSPORTATION period then it needs to acclimatise to room AND STORAGE temperature. before start up. This will allow any condensation that may UNPACKING have formed to dry. It will also stop the incubator from overshooting temperature set point. -
Page 8: Shelves And Usable Space
Instructions for use When it is level, secure the feet by tightening the lock nuts Empty the water tray if the incubator is switched off, with a 10 mm spanner. otherwise condensation will occur. SHELVES AND USABLE SPACE GAS CONNECTION Each incubator is supplied with 4 perforated stainless steel Risk of injury. -
Page 9: Getting Started
Instructions for use Further details can be found in the technical data. MAIN DISPLAY Section 12.1 The main displaysshow the current temperature and CO Plug the supplied power lead into the IEC connector on the conditions inside the chamber. If one of the displays is rear of the incubator. -
Page 10: Changing Temperature Set Point
Instructions for use under temperature alarms will “follow” the changes in your CHANGING TEMPERATURE SET chamber temperature. POINT For example: To change the chamber temperature: If the chamber temperature set point is 37.0 °C and the high alarm limit is +1.0 °C, the alarm will trigger at 38.0 °C (1.0 °C higher than the chamber temperature). -
Page 11: Igh And Low Co Alarms
Instructions for use Press Press (for 1 second). (for 1 second). will show in the left If an alarm sounds on start up, press Press to silence it. (for 1 second). will show in the left display. display. unds on start up, press Press to silence it. -
Page 12: Door Open Alarm
Instructions for use 5.13 DOOR OPEN ALARM HIGH TEMPERATURE STERILISATION alert you when the outer door has not been closed properly or when it has been left open for a period of 30 seconds Risk of damage to unit. or more. The 30 second delay timer should be suitable for The CO Standard D is not intended to be most users, but if more time is needed to load and unload... -
Page 13: Starting The Cycle
Instructions for use STARTING THE DECONTAMINATION CYCLE unds on start up, press Press to silence it. (for 1 second). will show in the left display and a value in the right display. unds on start up, press Press to silence it. (for 1 second). - Page 14 Instructions for use This improves recovery of the chamber back to ideal The shelves, racking and water tray can be sterilised in an conditions and reduces the amount of CO used. autoclave if required. Clean the glass door and the inner gasket seal. Clean the inner stainless steel surfaces of the outer door ACCESSORIES and the outer door gasket.
- Page 15 Instructions for use Volume Litres (cu. ft.) 190 (6.7) DISPOSAL Number of shelves 8 shelves Maximum of 8. SHIPPING DIMENSIONS The incubator must not be disposed of at Width mm (inches) 925 (36.4) public waste collection points. It must only Height mm (inches) 1080 (42.5)
- Page 16 Instructions for use CELL Standard 190_np_en 1301_mmm_V1.02...
- Page 17 Europ pean Directiv ve 2006/95/EC C, 2004/108/EC Medcenter E inrichtungen GmbH, Sem melweisstras sse 6, D-8215 52 Planegg / M München declare e on our own responsibility that product incub bator: All culture s safe touch an d precision CO O2 incubator CO2C CELL...
Need help?
Do you have a question about the CO2Cell 190 Standard and is the answer not in the manual?
Questions and answers