Operation Beeps; Upgrading Your Machine's Software - Brother Innov-Is M280D Operation Manual

Operation beeps

If a correct operation is performed, the machine beeps one
time.
If an incorrect operation is performed, the machine beeps two
or four times.
If the machine locks up, for example, because the thread is
tangled, the machine continues to beep for four seconds, and
then the machine automatically stops. Be sure to check for the
cause of the error, and correct it before continuing to sew.

Upgrading your machine's software

Upgrading your machine's software
You can use USB flash drive to upgrade software for your
machine.
When an upgrade program is available on our website at
" http://s.brother/cpjaa ", please download the file(s)
following the instructions on the website and steps listed
below.
Note
• When using USB flash drive to upgrade the software,
check that no data other than the upgrade file is saved
on the USB flash drive being used before starting to
upgrade.
a Turn on the machine while pressing and holding
(Needle position button).
 The following screen appears.
b Insert the USB flash drive into the USB port on the
machine. The media device should only contain the
upgrade file.
c Press .
 When upgrading is finished, the completion message
appears.
Remove the USB flash drive, and turn the machine off
d
and on again.
5
91