Energy-Saving Charging Mode - VXI V175 User Manual

ENERGY-SAVING CHARGING MODE

When this mode is activated, all headset functions will be disabled, except for headset battery charging .
To Activate the Energy-Saving Charging Mode:
• Unplug the headset base power adapter from the power outlet . Make sure all headsets are charged
before proceeding .
• Press and hold the pair button on the base, and, at the same time, plug the base power adapter back
into the power outlet . The mute LED on the headset base will start flashing after about 20 seconds and
then go out and the red Mode 1 LED will begin to flash . Do not release the pair button until the Mode 1
LED is flashing .
• Release the pair button and then press it again within 2 seconds .
• After 60 seconds, the base will enter energy-saving charging mode and all base LEDs will be off .
Note: When the energy-saving charging mode is successfully enabled, all LEDs on the base will be off.
Any headsets will also be deregistered from the base and will need to be registered back to the base
prior to use.
If the headset fails to enter this mode, repeat all steps above .
To Deactivate the Energy-Saving Charging Mode:
• Unplug the base power adapter from the power outlet, and then plug it back in . The headset base will
power up as normal .
• Register the headset back to the headset base . See the "Adding and Registering a Headset" section of
the user guide for instructions .
VXi V175 User Guide PAGE 17