Setting The Printer Paper / Setting An Sd Card - Tanita DC-430U Instruction Manual

Setting the Printer Paper /
Setting an SD Card
Setting the Printer Paper
1
(1) Turn the power OFF and push the
handle on the left hand side of the
controller.
(2) Open the printer cover.
(3) Set the printer paper in place.
Peel off the adhesive and pull out approximately
4inch (10cm) of paper from the printer paper.
(4) Replace the printer cover to its
original place.
2
Press
After all the indicators are displayed,
displayed.
If the device is turned on with the printer cover open,
is displayed.
3
Press
automatically, and the settings are
completed.
Paper is not automatically cut when 'Auto Cut' is set
to 'Off'.
Note
Cutting automatically setting
10 10
to turn on the device.
. The printer paper is cut
→ See
is
P.13 setting4
②
③
①
④