Table of Contents
Advertisement
Strong
flashes when out of range (NXDN Trunking only).
C
OMPANDER
If programmed by your dealer for a channel, the compander
will remove excessive noise from transmitted signals, to
provide higher clarity of signals.
Note: PTT ID can be made only in analog operation.
B
C
USY
HANNEL
On Conventional channels, if BCL is set up by your dealer, you
will be unable to transmit if the channel is already in use. Use
a different channel or wait until the channel becomes free.
If BCL Override has been programmed, you can transmit over
the current signal:
1 Press and hold the PTT switch.
•
If the channel is already in use, a warning tone will sound.
2 Quickly release and then press the PTT switch again.
3 Speak into the transceiver as you would during a normal call.
C
C
ONTROL
HANNEL
On digital Trunking channels, the transceiver automatically
searches for a control channel.
•
While searching for a control channel, the antenna icon will flash
(NX-200/ NX-300/ NX-200G/ NX-300G Only) and no signals can
be received.
PTT ID
PTT ID is the transceiver unique ID code which is sent each
time the PTT switch is pressed and/or released.
Note: PTT ID can be made only in analog operation.
Sufficient
L
(BCL)
OCKOUT
H
UNT
Weak
Very weak
31
Advertisement
Table of Contents
