EEG 491 Series Manual page 11

SD/HD Encode
Utilities
Test Captions
Capture VANC
9
SD/HD Encode allows you to use the aux path to simultaneously encode
matching captions to a synchronized source of SD Video. This feature is
off by default – to activate, select 'SD/HD Encode' by using the UP and
DOWN buttons to scroll through the list. Set SD/HD Encode to "On"
and press ENTER to save your selection or CANCEL to exit.
SD/HD Encode option should NOT be used simultaneously with
CCMatch activated in external delay mode. Doing so will produce
undesirable results.
The Test Caption menu allows you to enable a stream of caption text on
a single 608 channel of your choosing.
 Enable starts the stream of captions on the selected channel, which
is CC1 by default. To enable test captions use the UP and DOWN
keys to select ON. To disable test captions select OFF. Use the
ENTER key to apply the changes. The test captions will stop if any
other port (i.e. 232, modem or Linux virtual port) enters caption
mode on the same channel and automatically change Enable to
OFF.
 Set Channel allows you to select which 608 channel the test caption
stream will be appear on. The default channel is CC1. TO select a
different channel use the UP and DOWN keys to select a different
channel and press the ENTER key to apply the change.
Captures VANC data of the selected DID/SDID from the Master video
input and loads it onto a USB storage device. Use the UP and DOWN
keys to select the desired DID/SDID and insert a USB device into the
box. Press ENTER to begin downloading the VANC data or CANCEL
to exit. To stop capturing VANC data press any front panel key.
Depending on the size and type of memory device used, there may be a
momentary delay before the device is detected. If you see "Failed: Insert
USB Disk", wait a few seconds and try again.
Copyright © 2000-2014 EEG Enterprises, Inc.
All Rights Reserved.
HD491 Smart Encoder