Table of Contents
Advertisement
6.3
Rear View:
(1) Speaker Connection Terminals: Each one set of speaker connection terminals on the
left and right sides is used to connect to the speaker with more than 10W(L/R) and
8~15Ω.
(2) Stand.
(3) Four tapped holes for the Stand: Use the standard screws to fix the seat.
(4) Four tapped holes for the wall mount (optional): Use the standard screws to fix the
wall mount.
(5) Transport handles: Use the handles to facilitate the transport. When wall mount is
used, the handles shall be removed before assembling the Display with wall mount.
(6) Four tapped holes for the laud speakers: Use the standard hangers and screws to fix
the optional standard laud speakers.
(7) Signal input terminals: They are used to connect to input devices. Depending on
the selected modules, there are three combinations available for selection:
PC Module
A. D-Sub: Connects to the D-SUB 15 PIN analog output connector of the PC
B. DVI: Connects to the DVI-I digital output connector of the PC display card.
C. RS-232C: is a D-SUB 9 PIN male terminal used as a control port for serial
display card. The Display is used as a PC monitor.
The display is used as a PC monitor.
communication.
14
Advertisement
Table of Contents
