Example Of Macro Programming; Using A Programmed Macro Key - Honeywell First Alert FA168CPS User Manual

Macro Key Programming & Usage Macro Key Programming & Usage
Macro Key Programming & Usage Macro Key Programming & Usage
The keypad beeps to acknowledge your input and displays the command you
entered (followed by "F").
4. Enter the next command, followed by press/holding the "D" key for at least two
seconds. The keypad beeps and displays the keystrokes entered so far.
5. Repeat until the all the desired commands (up to 16 characters including the "F"s)
have been entered.
Be sure to check your keystrokes before continuing. If you made a mistake, you
must start over.
6. To exit, press/hold the "D" key for at least two seconds. The display returns to
system status and indicates system is ready.

Example of Macro Programming

Example of Macro Programming Example of Macro Programming Example of Macro Programming
Suppose you want to (1) bypass the two upstairs
window zones, then (2) turn on an exterior light, and
then (3) arm the security system in the AWAY mode.
The procedures in the table that follows show you how
you would program this macro:
Function
1. Bypass zones 02 & 03
2. Insert terminator.
3. Turn light on
(device 01).
4. Insert terminator.
5. Arm system AWAY
6. Insert terminator.

Using a Programmed Macro Key

Using a Programmed Macro Key
Using a Programmed Macro Key Using a Programmed Macro Key
DISARMED
READY TO ARM
ENTER USER CODE
* * * *
– 26 –
Keystrokes Required
Press BYPASS [6] key, then
2-digit zone numbers 02 & 03.
Press the "D" key for at least 2 seconds.
Press [#] and 7 keys for "device ON", and
[01] key for selecting device 1.
Press the "D" key for at least 2 seconds.
Press AWAY [2] key.
Press the "D" key for at least 2 seconds.
1. Press the Macro key programmed for the desired
series of commands for at least 2 seconds. The "Enter
User Code" prompt appears. The prompt remains
displayed for up to 10 seconds.
2. Enter your 4-digit security code.
The programmed macro sequence begins
automatically after the user code is entered.
(cont.) (cont.)
(cont.) (cont.)
Typical Macro Alpha Display:
MACRO PGM
6 0 2 0 3 F 7 0 1 F 2 F
#
Keypad Display
6 0 2 0 3
6 0 2 0 3 F
6 0 2 0 3 F # 7 0 1
6 0 2 0 3 F 7 0 1 F
#
6 0 2 0 3 F 7 0 1 F 2
#
6 0 2 0 3 F 7 0 1 F 2 F
#