Table of Contents
Advertisement
Cleaning and maintenance
en
Refit and screw on the pump cover.
5.
The handle must be in a vertical
position.
Close the service flap.
6.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into dispenser II and start the
Drain programme.
The drain hose at the siphon
is blocked
Turn the programme selector to Û
1.
(Off). Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
44
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse, Spin, Drain programmes).
Select the Start Reload button.
3.
Allow the programme to run for
approx. 40 seconds.
Turn the programme selector to Û
4.
(Off).
Pull out the mains plug.
5.
Clean the filters:
Disconnect the hose from the rear of
1.
the appliance.
Use pliers to remove the filter.
2.
Advertisement
Table of Contents
